Relay Activation (Cameras With Alarm I/O Only) - FLIR DND13TL2 Instruction Manual

5 Setup
4. Enter the number of seconds the camera will record after motion is detected under
Post Record.
5. Check Relay-out to trigger an external alarm device when the camera detects video
tampering. The camera must have an Alarm Output to use this function.
6. Enter the number of seconds before the camera will trigger the external device under
Alarm Delay.
7. Check PTZ (PTZ cameras only) and set the PTZ function from the Activation drop-
down list that appears. Enter the PTZ function number in the NO text box.
8. Check Send Email for the camera to send an email alert when video tamper is de-
tected. Email settings must be configured to receive email alerts.
9. Check Snapshot for the camera to save a snapshot when video tamper is detected.
SD / microSD card or FTP recording must be configured to use this function.
10. Click Save to save changes.

5.4.3 Relay Activation (Cameras with Alarm I/O Only)

The Alarm menu allows you to configure settings for alarm devices. Your camera must
have an alarm I/O connector to use alarm devices.
To configure alarm device settings:
1. Configure the following:
• Under Relay-In, select the alarm device you would like to configure.
• Check Enable to enable the selected alarm In device.
• Click Setup next to Working Period to set a schedule for alarm device activation.
• Under Anti-Dither, enter the latch time in seconds.
• Under Sensor Type, select NO (Normally Open) or NC (Normally Closed) depend-
ing on the type of sensor used.
• Check Record to record when a sensor device is triggered.
• Under Post Record, enter the amount of time the system will record when a sensor
device is triggered.
• Check Relay-out to activate an alarm output device (e.g. strobe light) when the
sensor device is triggered. The camera must have an alarm output to use this
feature.
• Enter the number of seconds before the camera will trigger the external device
under Alarm Delay.
• Check PTZ and set the PTZ function from the Activation drop-down list that ap-
pears. Enter the PTZ function number in the NO text box.
• Check Send Email for the camera to send out an alert email when the sensor de-
vice is triggered.
• Check Snapshot for the camera to save a snapshot to FTP or SD / microSD card
when the sensor device is triggered.
2. Click Save to save changes.
#LX400073; r.46243/46243; en-US
42