Ip Filter; Smtp (Email) - FLIR DND13TL2 Instruction Manual

5 Setup
6. Click Save.
NOTE
It may take between 10~15 minutes for the DDNS server to update with your new DDNS address.

5.2.5 IP Filter

The IP Filter menu allows you to create a white list of device MAC or IP addresses that can
access the camera. If you use the IP filter menu, devices that are not on the white list will
not be able to remotely connect to the camera.
NOTE
If you enable the IP filter the camera will block any device that is not listed. Make sure the correct devices
are added to the list, or you may not be able to access the camera.
To filter connections based on IP or MAC addresses:
1. Click Add IP/MAC.
2. Select IP Address, IP Segment, or MAC and then enter the address of the device you
would like to add to the white list.
3. Click Save.
4. Check the Trusted Sites check box.
5. Click Save to save changes.

5.2.6 SMTP (Email)

The SMTP menu allows you to set up email alerts for motion or alarms.
To configure SMTP Settings:
1. Under SMTP Server, enter the SMTP server address.
2. Under Port, enter the Port used by the server.
3. Check Anonymity if the server allows anonymous logins or uncheck to enter creden-
tials to access the server.
4. Under Username, enter the user name of the sender's account.
5. Under Password, enter the password of the sender's account.
6. Under Sender, enter the sender's email account.
#LX400073; r.46243/46243; en-US
29