FLIR DND13TL2 Instruction Manual page 35

5 Setup
2. Configure the following port settings:
• TCP Port: Enter the TCP (Client) Port number (default: 35000). The TCP port is
used to stream video to remote computers or mobile devices. The TCP Port must
be port forwarded to enable remote connection to your camera.
• UDP Port: Enter the UDP Port number (default: 35001). The UDP Port is used for
special applications only.
• HTTP Port: Enter the HTTP Port (default: 80). The HTTP Port is used to access the
camera's web interface. The HTTP Port must be port forwarded to enable remote
access.
NOTE
If you change the HTTP Port to anything other than 80, you must enter colon (:) and the HTTP
port in your web browser to access the camera (e.g. http://tomsmith.myddns-flir.com:85).
• RTSP Port: Enter the RTSP Port (default: 554). The RTSP Port is used for special
applications. For details on supported applications, see 5.2.13 RTSP Streaming
(Advanced — Select Network Cameras only), page 30.
3. (Optional) To enable HTTPS, check the HTTPs check box. To connect to the camera
using HTTPS, you must forward the HTTPS port (default: 443) on your router. You
must also connect to the camera using the following format:
• https://IP or DDNS address:HTTPS Port
• For example: https://tomsmith.myddns-flir.com:443
4. (Optional) To configure the HTTPS port, enter the custom port number under HTTPS
Port (default: 443).
5. Click Save to save changes.
5.2.2.1 ONVIF
The ONVIF tab allows you to configure ONVIF authentication. You can choose to enable
or disable ONVIF authentication. It is disabled by default.
To configure ONVIF settings:
1. Select the Enable radio button under Authentication.
NOTE
By default this option is disabled.
2. Click Save to save changes.
NOTE
To view the ONVIF version information from the camera's web-interface, go to Setup > Information
> Version.
#LX400073; r.46243/46243; en-US
27