Setup; Camera; Settings (Fixed Camera Series Only) - FLIR DND13TL2 Instruction Manual

5

Setup

The Setup menus allow you to configure camera settings.

5.1 Camera

5.1.1 Settings (Fixed Camera Series Only)

The Settings menu allows you to configure the image sensor settings for the camera. As
you make adjustments, the effects will be shown in the video display.
To configure the image sensor settings:
1. From the Profile drop down menu, select Normal, Day, or Night. You can configure
the image sensor settings differently for each profile, allowing you to quickly apply dif-
ferent settings if required.
2. Configure the following:
Picture
• Brightness: Adjust the brightness of the image between 0 and 100.
• Contrast: Adjust the contrast of the image between 0 and 100.
• Saturation: Adjust the color saturation of the image between 0 and 100.
• Sharpness: Adjust the sharpness of the image between 0 and 100. Higher sharp-
ness will make edges in the image clearer, but may increase noise in the picture.
• Gamma: Adjust the gamma level of the image between 0 and 100. The gamma lev-
el controls the balance between dark and bright parts of the camera image. It is rec-
ommended to keep this value near the mid-point as a low gamma level can produce
a washed-out image, and high gamma can create a dark, oversaturated image.
• Mirror: Select ON to flip the camera left and right.
• Flip: Select one of the options to flip the image or 0° to disable. Note that 90° rota-
tions are not supported if the Main Stream is set above 720p resolution.
NOTE
Select FLIR Network cameras support Corridor Mode. When setting the camera image to Corri-
dor Mode, flip the camera image to 90° and rotate your camera 90° counter-clockwise. For more
information about enabling Corridor Mode, visit
"Corridor Mode".
#LX400073; r.46243/46243; en-US
http://www.flir.com/security/pro and search for
13