Table of Contents
Advertisement
SECTION 6
6.0
SERVICE
MS-Series equipment has been designed using a subassembly concept. This
design feature allows for service by replacing a faulty assembly. The service
procedures described in this section will isolate a problem to the replaceable
assembly or component level as appropriate. Printed circuit board assemblies
are considered to be replacement items.
contactors, diode bridges, filter capacitors, etc. are considered replaceable
components.
For factory assistance call Pacific Power Source, Inc. at 800-854-2433 (in the
United States. For international support dial 1-949-251-1800)
This section is organized as follows:
Paragraph 6.1
Paragraph 6.2
Paragraph 6.3
Paragraph 6.4
Paragraph 6.5
Paragraph 6.6
Paragraph 6.7
6.1
DESCRIPTION
6.1.1 MAINFRAME DESCRIPTION
This paragraph describes the various assemblies and components of the
Mainframe. The function of each assembly and component is described below.
The part numbers listed are to be used when ordering spare assemblies and
components.
components.
Pacific Power Source ©2013
Provides a brief description of each assembly.
Provides
troubleshoot the system.
Provides step-by-step troubleshooting procedures.
This section contains schematic diagrams for the
LVPS, Input Power, DC Power Supply and Inverter
assemblies.
Provides
assemblies.
Provides
components.
Provides instructions for returning assemblies for
repair.
Refer to Figure 6.1.1 for the location of the assemblies and
6-1
Mainframe components such as
the
theory
of
operation
procedures
for
procedures
for
Document # 126050-10 Rev E
SERVICE
required
to
replacing
defective
replacing
defective
Advertisement
Table of Contents
Need help?
Do you have a question about the MS SERIES and is the answer not in the manual?