Setup Switches - Pacific Power Source MS SERIES Operation Manual

SECTION 4
4.5

SETUP SWITCHES

This paragraph describes the PC mounted dip switches contained within the MS-
Series AC Power Source, their purpose and location.
Every effort has been made to simplify the Power Source design and its
maintenance. To this end, many common components are used throughout the
product family. To maintain commonality within the product family, logic switches
are used to convey certain operating characteristics to the cabinet.
switches are summarized as follows:
1. Display PCB, Paragraph 4.5.1
S41:
S42:
2. Control PCB, Paragraph 4.5.2
S14:
Refer to Figure 4.5, Cabinet Assembly Drawing, for PC Board location.
ALL CABINET SWITCHES ARE FACTORY PRESET.
CHANGING ANY SWITCH POSITION, WITHOUT PROPERLY IDENTIFYING ITS
LOCATION AND PURPOSE, MAY CAUSE SERIOUS EQUIPMENT DAMAGE.

IF AUTO RE-START IS ENABLED, THE OUTPUT TERMINALS OF POWER SOURCE
MAY BE ENEGRIZED AUTOMATICALLY WHEN INPUT POWER IS APPLIED
Pacific Power Source ©2013
Machine ID and Baud Rate
For testing and future use.
Auto restart and AGC control.
CAUTION
WARNING
4-24
OPERATION
These
Document # 126050-10 Rev E