Assembly Replacement Procedures - Pacific Power Source MS SERIES Operation Manual

SECTION 6
6.5

ASSEMBLY REPLACEMENT PROCEDURES

This paragraph describes the various procedures to be used to replace
assemblies contained in the MS-Series mainframe.
!
THE SERVICE PROCEDURES OUTLINED IN THIS MANUAL ARE INTENDED FOR
USE ONLY BY PERSONNEL AUTHORIZED BY THE MANUFACTURER.
ALWAYS REMOVE ALL INPUT POWER FROM THE MAINFRAME PRIOR TO
ATTEMPTING ANY SERVICE TO THE EQUIPMENT.
LETHAL VOLTAGES ARE PRESENT INSIDE THE MAINFRAME WHEN INPUT
VOLTAGE IS APPLIED TO THE INPUT TERMINALS.
LETHAL VOLTAGES ARE PRESENT INSIDE THE MAINFRAME (ON THE DC BUS)
WHEN RED LEDS ARE LIT ON THE DISCHARGE PCB - EVEN IF INPUT VOLTAGE
IS NOT PRESENT AT THE INPUT TERMINALS.
Pacific Power Source ©2013
CAUTION

ELECTROCUTION HAZARD.
6-35
-
WARNING
Document # 126050-10 Rev E
SERVICE