Description Of Controls And Indicators - Pacific Power Source MS SERIES Operation Manual

SECTION 4
4.3

DESCRIPTION OF CONTROLS AND INDICATORS

The controls and indicators for the MS-Series equipment are located on the front
panel of the Power Source cabinet.
As shown in figure 4.3 the Front Panel is divided into 3 basic regions:
1. LCD and Interrogation Section. Used to solicit Power Source parametric
values.(Refer to paragraph 4.3.1)
2. Mode Select, Emer Off, and Start/Reset switches. Used to control the
operational state of the Power Source (Refer to paragraph 4.3.2).
3. Frequency Select and Volts Adjust. Used to control the Internal Oscillator
and select Master or Slave operation in Parallel Systems (Refer to paragraph
4.3.3).
Pacific Power Source ©2013
FIGURE 4.3 MS SERIES FRONT PANEL
4-4
OPERATION
Document # 126050-10 Rev E