Pacific Power Source MS SERIES Operation Manual page 11

SECTION 1
THIS EQUIPMENT CONTAINS HIGH ENERGY, LOW IMPEDANCE CIRCUITS!! LETHAL POTENTIALS
ARE CONTAINED WITHIN THE CABINET.
CARE MUST BE EXERCISED WHEN SERVICING THIS EQUIPMENT IN ORDER TO PREVENT
SERIOUS OPERATOR INJURY OR EQUIPMENT DAMAGE.
OBSERVE THE FOLLOWING WHEN SERVICE AND MAINTENANCE ARE REQUIRED:
1) REMOVE ALL JEWELRY FROM ARMS AND NECK WHEN SERVICING THIS EQUIPMENT.
THIS PREVENTS THE POSSIBILITY OF SHORTING THROUGH THE JEWELRY AND
CAUSING BURNS TO THE OPERATOR.
2) WEAR SAFETY GLASSES WHEN SERVICING THIS EQUIPMENT TO PREVENT EYE INJURY
DUE TO FLYING PARTICLES CAUSED BY ACCIDENTAL SHORT CIRCUIT CONDITIONS.
3) DO NOT REMOVE ANY PANEL OR COVER WITHOUT FIRST REMOVING THE INPUT
SERVICE BY OPENING ALL CIRCUIT BREAKERS.
4) SERVICE OTHER THAN EXTERNAL CLEANING SHOULD BE REFERRED TO PERSONNEL
AUTHORIZED BY THE FACTORY TO SERVICE THIS EQUIPMENT.
Cautions indicate a potentially hazardous situation which, if not avoided, may
result in minor or moderate injury. A caution also may be used to alert against
unsafe practices. Cautions will appear as shown below. All cautions should be
rigorously observed.
!
Read Section 3, INSTALLATION, and Section 4, OPERATION,
of this manual before installing or operating this equipment.
To protect equipment from damage a caution will be used as follows:
!
USING IMPROPER GAUGE OF INPUT CABLE MAY OVERHEAT AND DAMAGE THE
EQUIPMENT. SEE SECTION 2.0 SPECIFICATIONS FOR THE PROPER SIZING OF
Pacific Power Source ©2013
WARNING

CAUTION
CAUTION
INPUT CABLE.
1-2
GENERAL
-
Document # 126050-10 Rev E