Dive Log Mode - Uwatec Xtender Instruction Manual

• Press the D key from the default state to invoke the Air setting.
• When FO2 is set to any percentage from 22% to 99%, the NX flag lights up
when the dive computer is in Time mode, Alarm mode, Dual Time mode, Dive
Plan mode, Dive Set mode, or Dive mode. If FO2 is set to the default, the NX
flag flashes in the aforesaid modes.
b) Adjusting the USF setting
• The USF setting toggles between 0 and 1 each time the D key is pressed. (The
default setting is 0.)
• Pressing and holding the D key does not speed up USF adjustment.
c) Adjusting the Pt setting
• The Pt setting toggles between 30 and 15 each time the D key is pressed.
(The default setting is 30).
• Pressing and holding the D key does not speed up the Pt adjustment.
(3) PO2 maximum depth display function
• Displays the maximum depth at which a PO2 will remain below 1.4 at the FO2
setting.
• When FO2 is set to the default, bars appear in the FO2 segment. When set to
Air, the display does not appear.

3-9. Dive Log mode

• A mode in which data displayed, the data is saved if the diver stays submerged
for at least three minutes at a depth of 1.5 m or greater.
• Data is sequentially saved each time a dive is made. The dive computer can
hold log data for up to 30 dives. Once the 30-dive limit is reached, the oldest
log data is cleared each time a new dive is made.
25