Uwatec Xtender Instruction Manual page 43

3-13-3. Description of Dive mode functions
< Functions common to all states >
(1) EL backlight function
• In Dive mode, pressing the A key, C key, or D key causes the backlight to come
on for 2 to 3 seconds. (The A key and C key also invoke the demand display at
this time.)
• Continuously pressed and held keys are ignored. (The backlight stays on for 2
to 3 seconds from the time the key is first pressed.)
• Entries from the D key are ignored while the backlight is on. (The backlight
goes off 2 to 3 seconds after a key is pressed once.)
• If the A key or C key is pressed while the backlight is on, a demand operation
is performed, but the backlight stays on for 2 to 3 seconds from the time it was
first turned on.
(2) Depth measurement function
• Measures depth by means of an A/D converter, and calculates and displays
the depth value on the basis of the measurement.
• Measurement interval:
• Measurement range:
• Measurement start:
• Measurement stop:
• Display units:
• Anomolous display:
(3) Dive time measurement function
• This function measures dive time during depth measurment.
• Measurement range:
• Measurement start:
1 sec.
0.0 m – 99.9 m
from E key ON detection
to E key OFF detection
0.1 m (1 ft)
when depth measurement exceeds 99.9 m, bars
are displayed instead of numbers, as follows:
"– – – .–" m ("– – – "ft)
0 – 599 min.
begins when a depth of 1.5 m or greater is
detected
41