Uwatec Xtender Instruction Manual page 47

mode when the E key is OFF and the depth is 1.4 m or less, the lock state is
reset, and the same processing is performed as when a surface interval of 48
hours has elapsed. (This reset operation also works even if the surface interval
is less than 10 minutes.)
• When an out-of-range warning is issued, the lock state is instantaneously
invoked the moment a depth of 1.4 m or less is reached and the E key goes
OFF.
• Logs are finalized as usual after a surface interval of 10 minutes has elapsed.
< Example of when the depth has exceed the measurement limit >
At the point where the depth exceeds 99.9 m, bars appear in the current depth and maximum
depth segments, and all segments on the display flash.
(14) PO2 warning display
• If PO2 increases from a state of 1.3 or less and reaches 1.4 or 1.5, the PO2
value and PO2 flag flash for 15 seconds and an audible alarm sounds twice,
for three seconds each time.
45