Table of Contents
Advertisement
• Measurement stop:
• A dive time of 3 minutes or more is considered to be one dive, and the dive
number is incremented by a value of 1. At this point, log data can be saved in
memory. (If 600 minutes elapse, thereby taking the dive computer out-of-range,
the total dive time in the history will be saved as 600 minutes.) No log data is
saved for dive times of less than 3 minutes.
(4) Average depth calculation function
• This function calculates the average depth while in Dive mode.
• The average depth is displayed only in Dive Log mode.
• If the average depth exceeds 99.9 m (judged using meters), a bar display
appears on the Dive Log mode display.
(5) Maximum depth memory function
• The maximum depth reached since the start of the dive is saved in memory
and displayed in Dive Demand C.
• The maximum depth at the time the dive is finalized is saved in memory and
displayed in Dive Log mode.
• If the maximum depth exceeds 99.9 m, a bar display appears.
(6) PGT bar graph display function
• The Pressure of Gas in Tissue (PGT) value is indicated by a bar graph.
• The bar graph has from 1 to 9 bars. Once the PGT reaches 9, the diver has
entered a decompression dive.
• If the PGT reaches a value of 9 via a change in the altitude rank during the
surface interval state, Dive mode cannot be accessed even if the E key comes
ON, and an audible alarm sounds.
(7) Oxygen limited indicator bar graph display function
• The oxygen limited indicator (OLI) value is displayed by means of a bar graph.
• The bar graph has from 1 to 8 bars.
42
counting continues until the log is finalized upon
the elapse of a 10-minute surface interval.
Advertisement
Table of Contents
