Table of Contents
Advertisement
Ex. 1) If Screen 2 of log number 5 is displayed, then the dive computer moves
as follows:
5-2 ¡ 5-1 ¡ 4-1 ¡ 3-1 ¡ 2-1 ¡ 1-1
Ex. 2) If Screen 3 of log 17 is displayed, the dive computer moves as follows:
17-3 ¡ 17-1 ¡ 16-1 ¡ 15-1 ¡ ¡ 2-1 ¡ 1-1
• The log does not loop but only moves back and forth as follows:
history display
• Press and hold the C key or the D key to fast-forward to Screen 1 of each log.
Holding the C key:
1-1 ¡ 2-1 ¡ 3-1 ¡ ¡ 29-1 ¡ 30-1 ¡ history display
Holding the D key:
history display ¡ 30-1 ¡ 29-1 ¡ 28-1 ¡ ¡ 2-1 ¡ 1-1
• If an EEPROM access error occurs, or if there is no log data, a bar display will
appear when Dive Log mode is accessed.
• When the bar display appears, History Clear mode cannot be accessed.
• If FO2 is the default state, the display will show "– – "%, and the NX flag will
flash.
•
Alarm indicators
The following warnings are displayed in the log if they are recorded in Dive
mode:
• Ascent rate warning. If an ascent warning is continuously issued during a dive
and an ascent rate warning is saved in memory, the SLOW flag flashes.
• Decompression dive warning. If a decompression dive has been entered even
one time, a decompression dive warning is saved in memory and the DECO
flag lights up when the log is displayed.
• Decompression stop violation warning. If a decompression violation has
occurred even one time, a decompression stop violation warning is saved in
memory and the DECO flag flashes when the log is displayed.
• Out-of-range warning. If the diver dives beyond the measurement range, an
out-of-range warning is saved in memory and the display segment flashes
when the log is displayed.
30
newest
...
oldest
Advertisement
Table of Contents
