JLG t350 Service And Maintenance Manual page 111

12. Remove drive link (10) from coupling shaft (12) if it
was not removed with rotor set and wear plate.
Inspect drive link for cracks and worn or damaged
splines. No perceptible lash (play) should be noted
between mating spline parts. Remove and discard
seal ring (4) from housing (18).
13. Remove thrust bearing (11) from top of coupling
shaft (12). Inspect for wear, brinelling, corrosion and
a full complement of retained rollers.
14. Check exposed portion of coupling shaft (12) to be
sure you have removed all signs of rust and corro-
sion which might prevent its withdrawal through the
seal and bearing. Crocus cloth or fine emery paper
may be used.
3121198
SECTION 3 - CHASSIS & TURNTABLE
15. Remove coupling shaft (12), by pushing on the out-
put end of shaft. Inspect coupling shaft bearing and
seal surfaces for spalling, nicks, grooves, severe
wear or corrosion and discoloration. Inspect for
damaged or worn internal and external splines or
keyway. Replace coupling shaft if any of these con-
ditions exist.
NOTE: Minor shaft wear in seal area is permissible. If wear
exceeds 0.020 inches (0.51 mm) diametrically,
replace coupling shaft.
NOTE: A slight "polish" is permissible in the shaft bearing
areas. Anything more would require coupling shaft
replacement.
16. 16. Remove and discard seal ring (4) from housing
(18).
– JLG Lift – 3-75