JLG t350 Service And Maintenance Manual page 115

Hide thumbs Also See for t350:
Table of Contents

Advertisement

2. The Torqlink™ inner housing bearing/bushing (13)
can now be pressed into its counterbore in housing
(18) flush to 0.03 inch (.76 mm) below the housing
wear plate contact face. Use the opposite end of the
bearing mandrel that was used to press in the outer
bearing/bushing (19).
3121198
SECTION 3 - CHASSIS & TURNTABLE
3. Press a new dirt and water seal (20) into the housing
(18) outer bearing counterbore.
The Torqlink™ dirt and water seal (20) must be pressed in
until its' flange is flush against the housing.
– JLG Lift –
3-79

Advertisement

Table of Contents
loading

This manual is also suitable for:

T500j

Table of Contents