Resistance Measurement; Continuity Measurement - JLG t350 Service And Maintenance Manual

SECTION 7 - BASIC ELECTRICAL INFORMATION & SCHEMATICS

Resistance Measurement

Figure 7-2. Resistance Measurement
• First test meter and leads by touching leads together.
Resistance should read a short circuit (very low resis-
tance)
• Circuit power must be turned OFF before testing resis-
tance
• Disconnect component from circuit before testing
• If meter is not auto ranging, set it to the correct range
(See multimeter's operation manual)
• Use firm contact with meter leads
7-2

Continuity Measurement

Figure 7-3. Continuity Measurement
• Some meters require a separate button press to
enable audible continuity testing
• Circuit power must be turned OFF before testing conti-
nuity
• Disconnect component from circuit before testing
• Use firm contact with meter leads
• First test meter and leads by touching leads together.
Meter should produce an audible alarm, indicating
continuity
– JLG Lift – 3121198