Assembly - JLG t350 Service And Maintenance Manual

SECTION 3 - CHASSIS & TURNTABLE
6. Remove the rotor assembly and wear plate. Remove
the body seals from the rotor and housing and dis-
card the seals.
7. Remove the drive link pin and drive link from the
motor and lay aside.
8. Gently tap the shaft upward through the housing
and remove through the rear of the housing. Turn
the shaft over and remove the cooling plug.
9. Remove the housing from the vise and turn over. Pry
the dust seal from the housing.
10. Push the seal carrier, thrust washer, and thrust bear-
ing down and remove from the rear of the housing.
NOTE: When removing the seal carrier, thrust washer, and
thrust bearing take care not to scratch or nick the
housing bore.
11. If a new seal carrier and thrust washer are included
in the repair kit, the old items may be discarded. If
not, carefully pry the shaft seal, teflon backup seal,
and metal backup shim from the seal from the seal
carrier and discard the metal backup shim, backup
seal, and shaft seal. Lay the seal carrier aside.
12. Remove the wire ring, metal backup shim, and high
pressure seal from the inner bore groove of the
housing with a small screwdriver and discard them.
13. All parts should be cleaned in an oil based solvent
and dried using compressed air. All new seals
should be lightly coated in clean oil prior to installa-
tion.
3-32

Assembly

FOR PROPER OPERATION, THE MOTOR DEPENDS ON THE COR-
RECT ORIENTATION OF PARTS AS WELL AS THE CORRECT
INTERNAL TIMING.
1. Place the shaft on a clean flat surface with the output
end facing up.
2. Place the thrust bearing, then thrust washer, on the
shaft.
3. Install the shaft seal down onto the shaft making
sure the lip on the seal faces down. Refer to Figure
3-10., Seal Orientation.
METAL
BACKUP
SHIM
DUST SEAL
SPLIT WIRE
RING
Figure 3-10. Seal Orientation
4. Install the teflon backup seal onto the shaft with the
flat side up and the seal lip facing the shaft seal.
5. Place the metal backup shim onto the shaft and
against the teflon backup seal.
6. Place the seal carrier onto the shaft (large end
down) and carefully press the seal carrier down onto
the seal assembly using an arbor press and sleeve
to compress the seals into the carrier.
– JLG Lift –
TEFLON
SEAL
BACKUP
CARRIER
SEAL
METAL
HIGH
PRESSURE BACKUP
SEAL SHIM
SHAFT
SEAL
3121198