Outrigger Cylinder And Stabilizer; Removal - JLG t350 Service And Maintenance Manual

SECTION 3 - CHASSIS & TURNTABLE
3.16 OUTRIGGER CYLINDER AND
STABILIZER

Removal

1. Using the analyzer and service mode, lower the out-
rigger cylinder to be removed but DO NOT lower
enough that the outrigger is supporting any of the
machine's weight.
2. Place an appropriate lifting strap around the cylinder
and use an adequate lifting device to support the
weight of the cylinder.
NOTE: The outrigger cylinder weighs approximately 48 lbs.
(22 kg).
3. Use the lifting device to fully support the weight of
the outrigger cylinder. With the weight of the cylinder
relieved, remove the retaining clips securing the out-
rigger pin and outrigger cam pin and remove the
two pins.
4. Lift the outrigger cylinder slightly up out of the frame
to gain better access to the hydraulic lines running
to the cylinder. Tag and disconnect the lines from the
cylinder and cap or plug all openings.
3-60
5. At the opposite end of the cylinder, remove the bolt
and keeper securing the pin and remove the pin.
6. Remove the cylinder from the machine. If necessary,
remove the cylinder cover from the cylinder.
NOTE: Steps 7 and 8 are only necessary if removing the sta-
bilizer.
7. Place adequate blocking under the stabilizer to sup-
port it.
NOTE: The stabilizer on ANSI spec machines weighs
approximately 42 lbs. (19 kg). The stabilizer on CE
spec machines weighs approximately 46 lbs. 21 kg).
8. Remove the bolt and keeper securing the pin that
connects the stabilizer to the frame and remove the
pin.
– JLG Lift – 3121198