SECTION 3 - CHASSIS & TURNTABLE
17. Remove thrust bearing (15) and thrust washer (14)
Inspect for wear, brinelling, corrosion and a full com-
plement of retained rollers.
18.
Remove seal (16) and back up washer (17) from
Small Frame, housing (18). Discard both.
3-76
19. Remove housing (18) from vise, invert it and remove
and discard seal (20). A blind hole bearing or seal
puller is required.
20. Inspect housing (18) assembly for cracks, the
machined surfaces for nicks, burrs, brinelling or cor-
rosion. Remove burrs that can be removed without
changing
tapped holes for thread damage. If the housing is
defective in these areas, discard the housing assem-
bly.
– JLG Lift –
dimensional
characteristics.
Inspect
3121198