Disassembly/Reassembly Procedures: Replacement Procedures
2. After completing the PA-Unit Board Kit disassemble procedure, remove the lock plate [28]
from the connector assembly [30] by using a pair of long nose pliers as shown in
3. Pull the connector assembly [30] out of the Connector-Unit Board Kit [29] as shown in
Figure
6-76.
4. Using a CR-V PH2 screwdriver, remove the 2 taptite screws, M3x8 NI [14] from the
connector-unit board kit [29] as shown in
Figure 6-77. Removing Taptite Screws from Connector-Unit Board
6880309U09-A
Figure 6-75. Removing Lock Plate
Figure 6-76. Removing Connector Assembly
Figure
6-77.
1
2
6-41
Figure
6-75.
October 26, 2007