Figure 6-80. Sequence For Installing Connector-Unit Board Kit Screws; Figure 6-81. Installing Connector Assembly; Figure 6-82. Installing Lock Plate To Connector Assembly - Motorola PM1200 Basic Service Manual

Disassembly/Reassembly Procedures: Replacement Procedures
3. Using a CR-V PH2 torque driver, fasten the 2 taptite screws, M3x8 NI [14] to the
connector-unit board kit [29] as shown in
8.5–9.5 in. lbs).

Figure 6-80. Sequence for Installing Connector-Unit Board Kit Screws

4. Attach the connector assembly [30] to the connector-unit board kit [29] as shown in
Figure 6-79.
5. Attach the lock plate [28] to the connector assembly [30] as shown in
the lock plate [28] clamp the connector assembly [30] properly.
6880309U09-A

Figure 6-81. Installing Connector Assembly

Figure 6-82. Installing Lock Plate to Connector Assembly

Figure 6-80 (Torqued to 9.8–10.9 kgf*cm/
1
2
6-43
Figure 6-82. Ensure that
October 26, 2007