Pm1200 Control Head Panel-Interface Unit Board Kit Reassembly; Figure 6-16. Display Unit Board Screw Sequence; Figure 6-17. Connecting Speaker Mating Connector - Motorola PM1200 Basic Service Manual

6-10
3. Carefully align and insert the display unit board kit [22] to the key unit board kit [16].
NOTE: The male connector pin at the display unit board kit [22] might break if improperly assemble.
4. Carefully place the display unit board kit [22] to ensure the male connector pins are fully
engaged to the female connector.
5. Using a CR-V PH1 torque driver, fasten the 6 taptite head screws M2.6x6 [17] following the
sequence shown in
6. Carefully connect the speaker wire to the mating connector as shown in
7. Carefully seal the front housing assembly [10] with the rubber packing [11].

6.2.2.2.5 PM1200 Control Head Panel-Interface Unit Board Kit Reassembly

1. Carefully connect the connection cable to the mating connector on the rear of display unit
board kit [22] as shown in
October 26, 2007
Disassembly/Reassembly Procedures: Replacement Procedures
Figure 6-16 (torqued to 3.5–4.6 kgf*cm/ 3–4 in. Ibs).
4
5
1

Figure 6-16. Display Unit Board Screw Sequence.

Speaker Mating Connection

Figure 6-17. Connecting Speaker Mating Connector.

Figure 6-18.
2
6
3
Figure 6-5.
6880309U09-A