6-36
6. Using a CR-V PH2 torque driver, fasten 6 taptite screws M3x8 NI [14] follow the sequence as
shown in
Figure 6-66. Sequence for Installing Taptite Screws on PA-Unit Board Kit
7. Carefully resolder the 2 wires (Tx and Rx wires) as shown in
!
C a u t i o n
INSULATED WIRE
GROUND WIRE
October 26, 2007
Figure
6-66. (Torqued to 9.8–10.9 kgf*cm/ 8.5–9.5 in. lbs).
1
Ensure that the wires are soldered correctly to the PCB with the
insulated wires solder to TP1 002 (RX) and TP1 003 (TX) and ground
wire solder to TP1 001 (GND) and TP1 004 (GND).
TX WIRE
TX
GND
Figure 6-67. Resolder Tx and Rx Wire to PA-Unit Board Kit.
Disassembly/Reassembly Procedures: Replacement Procedures
5
6
2
3
RX WIRE
4
Figure
6-67.
INSULATED WIRE
RX
GND
GROUND WIRE
6880309U09-A