Figure 6-72. Connecting Power Wire Assembly To Pa-Unit Board Kit; Figure 6-73. Inserting Power Wire Assembly Into The Chassis - Motorola PM1200 Basic Service Manual

Disassembly/Reassembly Procedures: Replacement Procedures
12. Place the power wire assembly [37] to the terminal by using a CR-V PH2 torque driver and
fasten the taptite screw, M3x8 NI [14] to the PA-unit board kit [20]. (Torqued to
9.8–10.9 kgf*cm/ 8.5–9.5 in. lbs).

Figure 6-72. Connecting Power Wire Assembly to PA-Unit Board Kit

13. Place the power wire assembly [37] to the terminal by using a CR-V PH2 torque driver and
fasten the 3 SEMS screws, HSM3x6 NI [17] to the main-unit board kit [13] and PA-unit board
kit [20] follow the sequence. (Torqued to 5.8–6.9 kgf*cm/ 5–6 in. lbs).
!
C a u t i o n

Figure 6-73. Inserting Power Wire Assembly into the Chassis

6880309U09-A
Make sure the power wires are stored in the opening in the chassis.
3
1
1
2
6-39
October 26, 2007