Control Head Boards Disassembly/Reassembly; Pm1200 Control Head Disassembly; Pm1200 Control Head Back Housing Disassembly; Figure 6-1. Removing Screws From Cable Strain Relief Plate - Motorola PM1200 Basic Service Manual

6-2
Removal and insertion tool
Roto-Torq adjustable driver
Small, flat-blade screwdriver
Solder aid (black stick), Hexacon Electric Co.
Special Nut Driver
6.2.2

Control Head Boards Disassembly/Reassembly

The procedures in this section describe the disassembly and reassembly of each of the control head
boards.

6.2.2.1 PM1200 Control Head Disassembly

NOTE:Bracketed numbers are identical to item numbers shown in
Head Exploded View" on page

6.2.2.1.1 PM1200 Control Head Back Housing Disassembly

1. Turn off the radio.
2. Lay the control head face down on a clean, flat surface and be careful not to scratch or mar
the display.
3. Using a CR-V PH2 screwdriver, remove the 4 binding head screws M4x8 SUS B [34] from the
cable strain relief plate [32] as shown in
4. Carefully separate the cable strain relief plate [32] and gasket [31] from the back housing
assembly [29].
5. Carefully disconnect the remote radio control cable from the mating connector on the back
housing assembly [29] as shown in
October 26, 2007
Table 6-1. Required Tools and Supplies (Continued)
Tools and Supplies
9-2.
4
1
2
3

Figure 6-1. Removing Screws from Cable Strain Relief Plate

Disassembly/Reassembly Procedures: Replacement Procedures
Figure 6-1.
Figure 6-2.
Motorola
Part Number
6680163F01
RSX4043
–
MA-800G
6671833M01
Figure 9-1. "PM1200 Control
6880309U09-A