Motorola PM1200 Basic Service Manual page 131

Term
programming cable
PROM
PTT
Push-to-Talk
radio frequency
radio frequency
power amplifier
RAM
random access
memory
read-only memory
real-time clock
receiver
Receiver Back-End
IC
registers
repeater
repeater/talkaround
RESET
RF
RF PA
ROM
6880309U09-A
A cable that allows the CPS to communicate directly with the radio
using RS232.
See Programmable Read-Only Memory.
See Push-to-Talk.
The switch or button usually located on the left side of the radio which,
when pressed, causes the radio to transmit. When the PTT is released,
the unit returns to receive operation.
The portion of the electromagnetic spectrum between audio sound and
infrared light (approximately 10 kHz to 10 GHz).
Amplifier having one or more active devices to amplify radio signals.
See random access memory.
A type of computer memory that can be accessed randomly; that is, any
byte of memory can be accessed without touching the preceding bytes.
A type of computer memory on which data has been prerecorded. Once
data has been written onto a ROM chip, it cannot be removed and can
only be read.
A module that keeps track of elapsed time even when a computer is
turned off.
Electronic device that amplifies RF signals. A receiver separates the
audio signal from the RF carrier, amplifies it, and converts it back to the
original sound waves.
A custom integrated circuit providing a digital receiver intermediate
frequency (IF) backend.
Short-term data-storage circuits within the microcontroller unit or
programmable logic IC.
Remote transmit/receive facility that re-transmits received signals in
order to improve communications range and coverage (conventional
operation).
A conventional radio feature that permits communication through a
receive/transmit facility, which re-transmits received signals in order to
improve communication range and coverage.
Reset line: an input to the microcontroller that restarts execution.
See radio frequency.
See radio frequency power amplifier.
See read-only memory.
Definition
Glossary-5
October 26, 2007