Figure 6-54. Removing Power Wire Assembly From The Chassis; Figure 6-55. Removing Mating Connection From Pa-Unit Board Kit; Figure 6-56. Removing Screws From Antenna Connector - Motorola PM1200 Basic Service Manual

6-30
5. Carefully remove the power wire assembly [37] by using a pair of long nose pliers to push the
power wire assembly connector inward as shown in

Figure 6-54. Removing Power Wire Assembly from the Chassis

6. Separate the mating connector [D] of wire assembly [27] from the PA-unit board kit [20] as
shown in

Figure 6-55. Removing Mating Connection from PA-Unit Board Kit

7. Using a CR-V PH2 screwdriver, remove the 2 binding head screws, M3x6 SUS [6] from the
antenna connector [32] as shown in
October 26, 2007
Disassembly/Reassembly Procedures: Replacement Procedures
Figure 6-55.
Mating Connector [D]

Figure 6-56. Removing Screws from Antenna Connector

Figure 6-54.
Power Wire Assembly
Figure 6-56.
2
1
6880309U09-A