Disassembly/Reassembly Procedures: Replacement Procedures
4. Before reassembling the PCB to the chassis [11], put some thermal compound to the back of
the electronic component (Q2018) as shown in
NOTE:Refer
section 6.3: Chassis Thermal Compound Replacement Procedure on page
5. Tilt the main-unit board kit [13] and slide it into place; insert the connector through the
opening provided. Gently push down the PCB to fully seat it. Ensure the main-unit board kit
alignment holes are positioned over the chassis alignment bosses and the Main-unit board kit
is fully seated.
6880309U09-A
Figure 6-44. Position of Electronic Component – Q2018
Figure 6-45. Inserting Main-Unit Board Kit into Chassis
Figure
6-44.
Q2018
6-25
6-47.
October 26, 2007