Rf-Interface Board Kit Disassembly/Reassembly; Rf-Interface Board Kit Disassembly; Figure 6-33. Sequence For Installing Cable Relief Plate Screws; Figure 6-34. Installing Remote Radio Control Cable To Front Panel - Motorola PM1200 Basic Service Manual

Disassembly/Reassembly Procedures: Replacement Procedures
12. Using a CR-V PH2 torque driver, fasten the 4 binding head screws, M4x8 SUS B [1] to the
cable relief plate [2] following the sequence as shown in
5.8–6.9kgf*cm/ 5–6 in. lbs).

Figure 6-33. Sequence for Installing Cable Relief Plate Screws

6.2.3.2 RF-Interface Board Kit Disassembly/Reassembly

NOTE:Bracketed numbers are identical to item numbers shown in
Exploded View" on page

6.2.3.2.1 RF-Interface Board Kit Disassembly

1. Disassemble the front panel by following the steps outlined in
Panel Disassembly/Reassembly" on page 6-14.
2. Place the rear of the front panel facing upward on a flat surface and remove the 4 taptite head
screws, M2.6x6 [8] with a CR-V PH1 screwdriver as shown in

Figure 6-34. Installing Remote Radio Control Cable to Front Panel

3. Carefully separate the RF-Interface unit board kit [7] from the front panel [4].
6880309U09-A
4
1
2
3
9-3.
1
4
2
Figure 6-33. (Torqued to
Figure 9-2. "PM1200 Radio
6.2.3.1: "Transceiver Front
Figure 6-34.
3
6-19
October 26, 2007