6-46
4. Attach the Interface Board onto the Main Unit PCB. Then, using a CR-V PH2 torque driver,
fasten the provided taptite screw M2.6X6 to the chassis as shown in
3.5–4.6 kgf*cm/ 3–4 in. lbs).
5. Attach the thicker foam on top of the connector of option board as shown in
first removing the adhesive cover.
6. Attach the option board to the Interface Board as shown in
October 26, 2007
Disassembly/Reassembly Procedures: Replacement Procedures
Figure 6-87. Installing Interface Board to Chassis
Option Board
Figure 6-88. Paste Foam to Option Board
Figure 6-89. Attach Option Board to Interface Board
Interface Board
Foam
Figure
OPTION BOARD
Figure 6-87
(Torqued to
Figure 6-88
by
6-89.
6880309U09-A