Figure 6-19. Back Housing Screw Sequence; Figure 6-20. Installing Special Nut To Speaker Phone Jack - Motorola PM1200 Basic Service Manual

6-12
2. Using a CR-V PH2 torque driver to fasten the 4 binding head screws M4x8 SUS B [34] and
the 4 o-rings [33] to the back housing assembly [29] following the sequence following the
sequence as shown in
3. Insert the ear cap to the speaker phone jack at panel-interface unit board kit [25].
4. Using a special nut driver, fasten the special nut [26] as shown in
4.6–5.8 kgf*cm/ 4–5 in. lbs).
5. Carefully plug in the remote radio control cable to the mating connector on the back housing
assembly [29].
October 26, 2007
Disassembly/Reassembly Procedures: Replacement Procedures
Figure 6-19. (Torqued to 5.8–6.9 kgf*cm/ 5–6 in. lbs).
4
1

Figure 6-19. Back Housing Screw Sequence

Figure 6-20. Installing Special Nut to Speaker Phone Jack

2
3
Figure 6-20. (Torqued to
6880309U09-A