Figure 6-21. Installing Remote Radio Control Cable To Back Housing; Figure 6-22. Installing Screws To Cable Strain Relief Plate - Motorola PM1200 Basic Service Manual

Disassembly/Reassembly Procedures: Replacement Procedures
NOTE: Be careful not to damage the mating connector while plugging in the remote radio
Remote Radio Control Cable

Figure 6-21. Installing Remote Radio Control Cable to Back Housing

6. Neatly bundle the exposed cable wiring, and then install the cable strain relief plate [32] and
gasket [31] into the place.
7. Using a CR-V PH2 torque driver, fasten the 4 binding head screws M4x8 SUS B [34] to the
cable relief plate [32] follow the sequence as shown in
5.8–6.9 kgf*cm/ 5–6 in. lbs).
6880309U09-A
control cable.
4
1
2
3

Figure 6-22. Installing Screws to Cable Strain Relief Plate

Figure 6-21. (Torqued to
October 26, 2007
6-13