Figure 6-29. Installing Front Panel Screws; Figure 6-30. Installing Bottom Screws To Front Panel - Motorola PM1200 Basic Service Manual

Disassembly/Reassembly Procedures: Replacement Procedures
4. Using a CR-V PH2 torque driver, fasten the 2 binding head screws M3x6 SUS [6] to the front
panel [4] as shown in
5. Carefully lay the top of the radio facing downward on a clean, flat surface.
6. Using a CR-V PH2 torque driver, fasten the 2 binding head screws M3x6 SUS B [9] with
2 o-ring [10] to the front panel as shown in
3–4 in. lbs).
7. Lay the top of the radio facing upward.
8. Place the top cover [24] on the chassis [11] and seat it properly. Compress the cover and
chassis together to squeeze the foam [25] into place and to make torquing the screws easier.
6880309U09-A
Figure 6-29. (Torqued to 3.5–4.6 kgf*cm/ 3–4 in. lbs).

Figure 6-29. Installing Front Panel Screws

1

Figure 6-30. Installing Bottom Screws to Front Panel

2
1
Figure 6-29. (Torqued to 3.5–4.6 kgf*cm/
2
6-17
October 26, 2007