Connector-Unit Board Kit Disassembly/Reassembly; Connector-Unit Board Kit Disassembly; Figure 6-74. Sequence For Installing Top Cover Screws - Motorola PM1200 Basic Service Manual

6-40
14. Place the top cover [24] on the chassis [11] and seat it properly. Compress the cover and
chassis together to squeeze the foam [25] into place and make torquing of the screws easier.
15. Using a CR-V PH2 torque driver, fasten the 7 binding head screws M3x6 SUS B [23] to the
top cover [24] follow the sequence as shown in
5–6 in. lbs).

6.2.3.5 Connector-Unit Board Kit Disassembly/Reassembly

NOTE:Bracketed numbers are identical to item numbers shown in
Exploded View" on page

6.2.3.5.1 Connector-Unit Board Kit Disassembly

1. Before disassembling the FR-Interface board kit, perform a complete PA-Unit Board Kit
disassembly by following the steps outlined in
page 6-28.
October 26, 2007
Disassembly/Reassembly Procedures: Replacement Procedures
5
2
1

Figure 6-74. Sequence for Installing Top Cover Screws

9-3.
Figure 6-74
4
3
6
7
6.2.3.4.1: "PA-Unit Board Kit Disassembly" on
(Torqued to 5.8–6.9 kgf*cm/
Figure 9-2. "PM1200 Radio
6880309U09-A