Roland TrueVIS SG-300 User Manual page 65

2.
Remove the p rinted media f rom the p rinter.
Remove the printed media. Here you can perform laminating or other operation that does not use
this machine.
3.
Load the media again, and then cut it.
A
se our so t are I to con gure the settings to detect cro marks during cutting
The crop marks are automatically detected during cutting, and the cutting position is aligned with
the printing position. For information on how to make the setting, refer to the documentation for
the software RIP you're using.
B
Load the media that y ou removed in step
" P . 2 9 , " S t e p 1 : L o a d i n g Ro l l M e d i a ( S e t u p o f M e d i a ) "
P o in t s f or Loading the Media Again
Place the crop marks on the blade protector.
Angled no more than 5 degrees. Otherwise alignment becomes impossible.
C
Send the cutting data f rom the comp uter.
The crop marks are automatically detected to align the positions and cut the media.
2
. in the machine again.
C r o p m a r k B l a d e p r o t e c t o r
P rinting and Cutting with Crop Mark s
S e t t o 5 ° o r l e s s .
2
6 3