Roland TrueVIS SG-300 User Manual page 45

E
P ress [ ] or [ ] to select the correction value.
F
ress to con rm our entr
G
P ress [ ] to select " Y ES."
H
ress to con rm our entr
The test pattern is printed again. Check that the misalignment is minimized for the two vertical lines
indicated by " " (that is, the current correction value). If the misalignment is smaller for another
set of vertical lines return to step
If you do not need to change the correction value, press [ENTER] again.
I
P ress [ ] to select " DO NE."
J
ress to con rm our entr
6.
Decide to p erf orm the setting f or cutting or not.
A
P ress [ ] or [ ] to select " NEX T" or " SET."
Select "NEXT" when you will only perform printing. Select "SET" when you will perform cutting
(including printing and cutting as well as crop mark printing and cutting).
B
ress to con rm our entr
If you select "SET," proceed to the next procedure.
If you select "NEXT," proceed to step
7.
Set the blade f orce. (Sep arate setting "
M EM O
For high-quality cutting, perform a cutting test to check the cutting quality for the media and adjust
the blade force.
E to perform the setting again.
.
10
)
P . 13 3
B asic P rinting Method
43
2