Roland TrueVIS SG-300 User Manual page 58

B asic P rinting Method
D
Check that the screen shown below (the top menu) is disp lay ed.
If the top menu is not displayed, press [MENU].
If the [PRESS ENTER KEY TO CONTINUE] message appears on the screen, press [ENTER].
W1100mm
E
2
Send the outp ut data f rom the comp uter.
Create the output data using drawing application software. For information on how to create the
data, refer to the documentation of your application software.
To perform cutting or printing and cutting, you have to include the cutting data in the output data. For
information on how to create cutting data, refer to the documentation for the included software RIP.
M EM O
When you send the output data, "FILLING" or "CLEANING" may be displayed on the screen. These
indicate the preparation operations performed before output. Output will begin after the time
displayed on the screen elapses.
Im p ortant : O ut p ut is not p ossible in these si tua tio ns .
• The machine does not run when a cover (front, left, or right) is open.
• Never open a cover (front, left, or right) while output is in progress. Doing so interrupts printing.
• Data from the computer is not accepted when [SETUP] is dark.
• Printing does not start until [HEATER] lights. (If both "PRINT HEATER" and "DRYER" are set to "OFF,"
printing is possible even if [HEATER] is not lit.)
" P . 117 , " S e t t i n g t h e Te m p e r a t u r e d u r i n g P r e h e a t i n g "
• Data from the computer is not accepted when you are not at the top menu.
Im p o rtan t : P oints that must be obse r ved
• When you are performing printing, be sure to attach the media clamps. Otherwise the edges of the
media may warp and catch on the print heads.
• During output, do not touch the media. Doing so may obstruct the media feed or cause the media to
rub against the print heads, which may result in a paper jam or damage to the heads.
• Keep the loading lever raised when the machine is not in use.
Imp ortant: W hen not using the machine, remove any media and store it in a suitable environment.
• If the machine is left with the media loaded, the media may be damaged, which may adversely a ect
printing. When not using the machine, remove any media and store it in a suitable environment.
5 6