Roland TrueVIS SG-300 User Manual page 147

3.
Set the correction values.
A
P ress [ ] twice to disp lay the screen shown below.
B
P ress [ ENTER] .
The test pattern (C&C2) is printed and cut.
C
P ress [ ] to disp lay the screen shown below.
SETTING
D
Check the correction values f rom the test p attern (C& C2 ) condition.
The point where the cutting line intersects the correction-value scale is the correction value. Check
the scan direction (the direction of print head movement) and the feed direction (the media feed
direction).
C o r r e c t i o n -v a
F e e d d i r e c t i o n
E
P ress [ ] .
F
Set the correction values f or the f eed direction " F" and the scan direction " S."
1
P ress [ ] or [ ] to set the correction value f or the f eed direction (F).
F:+0.30 -0.30mm
S:-0.40 -0.20mm
2
P ress [ ] or [ ] to set the correction value f or the scan direction (S).
F:+0.30 -0.30mm
S:-0.40 -0.20mm
3 hen ou ha e nished setting the correction alues, ress
Advanced Settings f or P rinting and Cutting with Crop Mark s
S c a n d i r e c t i o n
l u e s c a l e
C u t t i n g l i n e
C u t t i n g l i n e
I n t h i s c a s e , t h e c o r r e c t i o n
v a l u e i s " -0. 3 . "
145
4