Roland TrueVIS SG-300 User Manual page 143

G
Set the correction values f or the f eed direction " F" and the scan direction " S."
1
P ress [ ] or [ ] to set the correction value f or the f eed direction (F).
F:+0.30 -0.30mm
S:-0.40 -0.20mm
2
P ress [ ] or [ ] to set the correction value f or the scan direction (S).
F:+0.30 -0.30mm
S:-0.40 -0.20mm
3 hen ou ha e nished setting the correction alues, ress
H
P ress [ P AUSE] to disp lay the screen shown below.
I
P ress [ P AUSE] again to restart the cutting op eration.
At this time, holding down [PAUSE] for one second or longer cancels the cutting operation.
"
P . 7 4 " P a u s i n g o r C a n c e
Descrip tion
With this machine, you can pause a cutting operation to correct the misalignment of the printing and cutting
positions. The correction values set here are applied as the default values of the printing and cutting positions.
If the printing and cutting positions are misaligned, you normally adjust the positions while checking a test
pattern.
"
P . 13 5 " C o r r e c t i n g t h e M i s a
Def ault Settings
[F] (correction value of the media feed direction): 0.00 mm
[S] (correction value of the cutting carriage movement direction): 0.00 mm
l i n g O u t p u t "
l i g n m e n t o f t h e P r i n t i n g a n d C u t t i n g P o s i t i o n s "
Advanced Cutting Settings
141
4