Roland TrueVIS SG-300 User Manual page 199

Included items
*1
The media holders of this machine are designed to be used exclusively with media that has a paper tube (core) with
an inner diameter of 3 inches. To use 2-inch media, the optional media anges are required.
*2
The length of printing or cutting is subject to the limitations of the program.
*3
• 500 gf is the maximum instantaneous blade force.
• The blade force must be adjusted according to details such as the media thickness.
*4
• Media type: Media speci ed by Roland DG Corp.
• Temperature: 25°C (77°F), humidity: 50%
• Roll media must be loaded correctly.
• Applicable when all pinch rollers that can be used with the media width are used.
• Side margins: 25 mm (1.0 in.) or more for both the left and right margins
• Front margin: 35 mm (1.4 in.) or more
• Excluding expansion/contraction of the media
• Not guaranteed when the print heater or dryer is used.
• Assumes all correction and adjustment functions of the machine have been used properly.
*5
• Print travel: 1 m (39.4 in.)
*6
• [PREFEED] menu item must be set to "ENABLE."
Range for assured repetition accuracy
54-inch model
• For media with a width exceeding 610 mm (24.0 in.): Length 4,000 mm (157.5 in.)
• For media with a width of 610 mm (24.0 in.) or less: Length 8,000 mm (315.0 in.)
30-inch model
Length 4,000 mm (118.2 in.)
*7
• Provided that the media feed length is 3,000 mm (118.1 in.) or less.
• Excludes the e ects of slanted movement and of expansion and contraction of the media.
*8
• Data size:
54-inch model
1,000 mm (39.4 in.) in the media-feed direction, 1,346 mm (53.0 in.) in the carriage-movement direction
30-inch model
1,000 mm (39.4 in.) in the media-feed direction, 736 mm (29 in.) in the carriage-movement direction
• No lamination
• Automatic detection of crop marks at 4 points when media is reloaded
• During cutting, [PREFEED] menu item must be set to "ENABLE."
• Excluding possible shift caused by expansion/contraction of the media and/or by reloading the media.
*9
• Warm-up is required after the power is turned on. This may require 5 to 20 minutes, depending on the operating
environment.
• Depending on the ambient temperature and the media width, the set temperature may not be reached.
*10
• Operating environment
Dedicated stands, power cord, media clamps, media holders, replace-
ment blade for separating knife, User's Manual, etc.
Use the machine in an operating
environment within this range.
eci cations
7
19 7