Roland TrueVIS SG-300 User Manual page 51

H
Set the correction values f or the f eed direction " F" and the scan direction " S."
1
P ress [ ] or [ ] to set the correction value f or the f eed direction (F).
F:+0.30 -0.30mm
S:-0.40 -0.20mm
2
P ress [ ] or [ ] to set the correction value f or the scan direction (S).
F:+0.30 -0.30mm
S:-0.40 -0.20mm
3 hen ou ha e nished setting the correction alues, ress
The test pattern (C&C1) is printed and cut again. Check the condition of the test pattern to check
whether the printing position and the cutting position are aligned.
I
< Cutting p osition and p rinting p osition are not aligned>
P ress [ ] to select " Y ES."
< Cutting p osition and p rinting p osition are aligned>
P ress [ ] to select " DO NE."
J
ress to con rm our entr
If you select "YES," the test pattern (C&C1) is printed and cut again. Go back to step
the setting again.
If you select "DONE," proceed to the next procedure.
10.
Set the dry ing method and time af ter p rinting. (Sep arate setting "
A
P ress [ ] or [ ] to select " ENAB LE" or " DISAB LE."
C u r r e n t S e t t i n g a f t e r
s e t t i n g c h a n g e
M EM O : Dr y ing Method a f ter P r inting
Set whether the media should be fed until the trailing edge of the printed area is put on the dryer
after the 1st page is printed. To make sure to dry the entire printed area, select "ENABLE." If "DISABLE"
is selected, the trailing edge of the printing area is not fed to the dryer unless you continue with a
subsequent printing operation.
B asic P rinting Method
G and perform
)
P . 119
49
2