Roland TrueVIS SG-300 User Manual page 134

Advanced Cutting Settings
D
P ress [ ] or [ ] to select the cutting condition y ou want to set.
Set the force (pressure) of the blade. (Default setting: 50 gf )
Set the speed of cutting. (Default setting: 30 cm/s)
SPEED
Set the blade o set. Enter the listed o set value for the blade. (The o set value for the included
blade is 0.25 mm (9.8 mil).) (Default setting: 0.250 mm)
Set the blade's up speed during cutting (the speed at which the blade travels when it moves to the
next cutting line after cutting one cutting line). If the media comes loose during no-load feed and
the blade damages the surface of the media, reduce the speed. (Default setting: 30 cm/s)
UP-SPEED
4
E
P ress [ ] to disp lay the screen shown below.
FORCE
50 gf
SPEED
30 cm/s 30 cm/s
OFFSET
0.250mm 0.250mm
UP-SPEED
20 cm/s 20 cm/s
F
P ress [ ] or [ ] to select a value.
G
ress
H
P ress [ ] to go back to p rocedure
Repeat procedure
I
P ress [ FUNCTIO N] to go back to the original screen.
132
50 gf
to con rm our entr
D
D and E to adjust respective cutting conditions.
.