Roland TrueVIS SG-300 User Manual page 191

Message
[ P I N C H RO L L E RRO R
* * * F RO M RI G H T]
[ W RO N G C A RTRI D G E ]
[ C A N C E L E D F O R
P U M P P RO TE C TI O N ]
[ A V O I D I N G D RY -U P
TU RN P O W E R O F F ]
[ S E T H E A D H E I G H T
TO x x x ]
Situation/error cause
The middle pinch rollers are
positioned at locations where
they cannot pinch the media.
There are too many middle
pinch rollers installed.
Has an ink pouch that cannot
be used been installed?
The printer made an emergen-
cy stop because the following
state has continued for 10 min-
utes or longer while cleaning
(normal, medium, powerful,
super, or automatic cleaning
while sub power was switched
o ) was in progress or during
the rst ink lling procedure for
the machine.
The print heads were forced to
the home position to prevent
them from drying out.
Is the height of the print heads
lower than the height speci ed
in the software RIP?
An Error Message Ap p ears
Action
Raise the loading lever and move the middle pinch
rollers to the correct location.
" P . 2 9 " S t e p 1 : L o a d i n g Ro l l M e d i a ( S e t u p o f M e d i a ) "
" P . 7 0 " L o a d i n g S h e e t M e d i a ( S e t u p o f M e d i a ) "
Raise the loading lever, and then remove all middle
pinch rollers that are not positioned above grit roll-
ers. The number of middle pinch rollers used varies
according to the width of the loaded media.
" P . 2 9 " S t e p 1 : L o a d i n g Ro l l M e d i a ( S e t u p o f M e d i a ) "
" P . 7 0 " L o a d i n g S h e e t M e d i a ( S e t u p o f M e d i a ) "
Remove the pouch tray to clear the error. Use an ink
pouch of the speci ed type.
Operation cannot be continued. Switch o the sub
power. After you switch o the power, contact your
authorized Roland DG Corp. dealer.
Operation cannot be continued. Switch the sub
power o , then back on.
This warning indicates that the height of the print
heads is too low for the media thickness speci ed
in the software RIP. The print heads move to a loca-
tion where you can operate the height-adjustment
lever. Adjust to the displayed height, and then
press [ENTER].
" P . 12 4 " A d j u s t i n g P r i n t H e a d H e i g h t t o M a t c h
Th i c k n e s s "
M e d i a
6
18 9