Roland TrueVIS SG-300 User Manual page 40

B asic P rinting Method
C
V iew the p rinted test p attern, and then determine the correction values f rom " B I-DIR
NO .1 H 1 " and " B I-DIR NO .1 H 2 ."
The test pattern is made of groups of two lines. Select the value that gives the least misalignment
between the two lines. In the case of the following gure, select "+5" for H1, "+4" for H2. When you
cannot choose between two sequential numbers, select a value that is between them (you can set
correction values in units of "0.5").
2
D
Set the correction values f rom " H 1 " to " H 2 ."
1
P ress [ ] or [ ] to select the correction value.
H1
0
2 hen ou ha e nished setting the correction alues, ress
The screen shown below appears again.
E
P ress [ ] to disp lay the screen shown below.
F
Set the correction values f rom " B I-DIR NO .2 H 1 " to " B I-DIR NO .2
manner as step
38
H2
0
D
.
H 2 " in the same