Roland TrueVIS SG-300 User Manual page 62

B asic Settings f or Cutting
C
P eel of f the cut shap es to verif y the cutting q uality .
2
< Two shap es are p eeled of f sep arately >
You do not need to perform the setting because the blade force is appropriate.
< Two shap es are p eeled of f together/back ing p ap er is also cut>
Proceed to the next step to set the blade force.
D
P ress [ ] or [ ] to select a value.
< Two shap es are p eeled of f together>
Raise the blade force.
< B ack ing p ap er is also cut>
Reduce the blade force.
E
ress
F
P ress [ FUNCTIO N] to go back to the original screen.
G
Rep eat step
At the [CUT CONFIG] menu, you can also make settings for other cutting conditions in addition to the blade
force. Refer to the following page.
" P . 13 1, " F i n e -t u n i n g t h e C u t t i n g C o n d i t i o n s "
6 0
to con rm our entr
1
to check whether the correction was successf ul.