Roland TrueVIS SG-300 User Manual page 44

B asic P rinting Method
G
P ress [ ] to select " Y ES."
H
ress
The test pattern is printed again. Check that the gap and overlap are the smallest for the gure in-
2
dicated by "
gure, return to step
If you do not need to change the correction value, press [ENTER] again.
I
P ress [ ] to select " DO NE."
J
ress
5.
P er f orm the correction f or misalignment in bidirectional p rinting. (Se p arate setting "
A
P ress [ ] to select " SET."
B
ress
The test pattern of bidirectional correction is printed.
You can select "NEXT" and press [ENTER] to proceed to the next menu.
C
P ress [ ENTER] .
INPUT
D
V iew the p rinted test p attern, and then determine the correction values.
Select the value that gives the least misalignment between the two lines. In the case of the following
gure, select "+5." When you cannot choose between two sequential numbers, select a value that
is between them (you can set correction values in units of "0.5").
42
to con rm our entr
" (that is, the current correction value). If the gap and overlap are smaller for another
E to perform the setting again.
to con rm our entr
to con rm our entr
)
P . 12 0