Roland TrueVIS SG-300 User Manual page 56

B asic P rinting Method
2.
P erf orm normal cleaning.
A
P ress
[ FUNCTIO N]
B
P ress [ ] , [ ] , then [ ] to disp lay the screen shown below.
CLEANING
NORMAL CL.
2
C
Check f or the group with dot drop -out by viewing the p rinting-test results.
D o t d r o p -o u t
D
P ress [ ENTER] .
The screen shown below appears, and then cleaning starts. The (approximate) remaining time for
the procedure is displayed on the screen. (The display shown below is an example. "01:45" = "1
minute and 45 seconds")
CLEANING...
>>
When nished, the screen shown below appears again.
NORMAL CL.
E
P ress [ FUNCTIO N] to go back to the original screen.
F
Rep eat step
M EM O
When performing continuous test prints, there is no need to set the base point from the second
print onward. However, the base point will be restored to its default and it will be necessary to set
it again if any of the following operations are made between printing operations.
• Sheet cutting
• Printing and cutting of output data you created
• Setup cancellation
5 4
.
01:45
1
to mak e sure the dot drop -out has been corrected.
I the rinting test esults re i cult
to Interp ret
Examine the results from di erent angles
in a well-lighted location. Take advantage
of re ected light to enable visual checking.