Roland TrueVIS SG-300 User Manual page 138

Advanced Cutting Settings
F
Check the test p attern (P & C1 ).
Check whether the printing position and the cutting position are aligned.
If the printing position and the cutting position are aligned, no corrections are necessary.
If the printing position and the cutting position are not aligned, proceed to the next procedure.
3.
Set the correction values.
A
P ress [ ] twice to disp lay the screen shown below.
4
B
P ress [ ENTER] .
The test pattern (P&C2) is printed and cut.
C
P ress [ ] to disp lay the screen shown below.
SETTING
D
Check the correction values f rom the test p attern (P & C2 ) condition.
The point where the cutting line intersects the correction-value scale is the correction value. Check
the scan direction (the direction of print head movement) and the feed direction (the media feed
direction).
C o r r e c t i o n -v a
F e e d d i r e c t i o n
E
P ress [ ] .
136
P r i n t i n g p o s i t i o n a n d c u t t i n g
p o s i t i o n a r e m i s a l i g n e d .
l u e s c a l e
C u t t i n g p o s i t i o n
P r i n t i n g p o s i t i o n
P r i n t i n g p o s i t i o n a n d c u
p o s i t i o n a r e a l i g n e d .
S c a n d i r e c t i o n
C u t t i n g l i n e
t t i n g
C u t t i n g l i n e
I n t h i s c a s e , t h e c o r r e c t i o n
v a l u e i s " -0. 3 . "