Roland TrueVIS SG-300 User Manual page 49

3 hen ou ha e nished setting the correction alues, ress
The test pattern (P&C1) is printed and cut again. Check the condition of the test pattern to check
whether the printing position and the cutting position are aligned.
I
< Cutting p osition and p rinting p osition are not aligned>
P ress [ ] to select " Y ES."
< Cutting p osition and p rinting p osition are aligned>
P ress [ ] to select " DO NE."
J
ress to con rm our entr
If you select "YES," the test pattern (P&C1) is printed and cut again. Go back to step
the setting again.
If you select "DONE," proceed to the next procedure.
9.
Correct the misalignment o f the p rinting and cutting p ositions when using cro p
mark s. (Sep arate setting "
M EM O
When you remove the printed media, and then reload it and perform cutting, use the crop marks.
For this case, correction is to be performed because the positioning of printing and cutting may
be misaligned even when you are using crop marks depending on the composition of the media.
A
P ress [ ] or [ ] to select " NEX T" or " SET."
Select "NEXT" when you will not print crop marks. Select "SET" when you will print crop marks.
B
ress to con rm our entr
If you select "SET," the test pattern (C&C1) is printed and cut. Proceed to the next procedure.
If you select "NEXT," proceed to step
)
P . 144
.
10
B asic P rinting Method
G and perform
47
2